Can you match my Colorbond colour?

If it is in the current BlueScope range, exactly. If it has been discontinued, we match to the nearest current colour and show you the sample against your fence before ordering. If the difference bothers you, the option is to replace the sheets on the visible face so it reads as one colour.

Why is my Colorbond fence rusting? It is supposed to be rust-proof.

The sheet is; the cut edge is not. Where a sheet was cut on site and the edge never sealed, moisture gets under the coating and rust creeps in from the edge. Caught early it is cut back and sealed. Coastal fences do it faster.

Sheets blew out of my fence in a storm. Why?

Usually because the rail clips that hold the sheets in were never fitted, or the rail was not specified for your wind exposure. We refit with clips and, on exposed sites, recommend a heavier rail. A storm blowing out sound sheets is generally an insurance claim.

Can a dented Colorbond sheet be repaired without replacing it?

A shallow dimple can be left or lived with. A crease through the sheet cannot be beaten out cleanly; it is replaced. Beating a Colorbond sheet cracks the coating and starts rust.

How do I find out what colour my fence is?

The colour name is often on the original invoice, sometimes written inside a post cap, and we can identify most colours by eye against the current range. Bring a photo in daylight; colours read differently in shade.

Fence Repair Guide

Colorbond Fence Repair Melbourne

Colorbond does not rot, warp or get eaten, which is why people buy it. It dents, it can rust where it was cut, its sheets blow out of their rails in a big wind, and its colour range changes every few years, so a repair in the wrong shade is worse than the dent. This page is about the four ways a steel fence needs repair, why they are almost always sheet-by-sheet jobs rather than run jobs, and how the colour match is done when the fence is older than the current range.

Get a Quote See Pricing

Sheet-by-sheet, not run-by-runMatched to the current BlueScope rangeDiscontinued colours: nearest match, or one faceEdge rust cut back and sealed, not painted over

How a steel fence fails, and why the fix is usually one sheet

A Colorbond fence is a set of steel sheets slotted into a top and bottom rail between posts. The sheets carry no load; the rails and posts do. That is what makes it so repairable: a dented, holed or rusted sheet is lifted out of its rails and a new one dropped in, without touching the sheets beside it. The problems come in four kinds. Dents and holes from a vehicle, a mower or a falling branch are cosmetic unless the sheet is creased through, and a creased sheet is replaced rather than beaten out. Edge rust appears where a sheet was cut on site and the cut edge was never sealed; it creeps in from the edge and lifts the paint. Caught early it is cut back and sealed; left, the sheet is replaced. Blown-out sheets are a wind problem, usually where the rail clips were never fitted or the fence is a wind zone the rails were not specified for, and the fix is refitting with clips or a heavier rail. And rusted or dropped rails and post caps, which let water into the posts, are replaced as parts. The one thing that is not a sheet job is colour: a fence in a colour BlueScope no longer makes cannot be matched exactly, and the honest options are a nearest current match or replacing the whole visible face.

Built To Spec

How we put a damaged fence back together

Fence build-upNOT TO SCALE

Structural repair

Post concrete20MPa, 600mm; galvanised steel post if replaced

Timber treatmentNot applicable; steel rails, posts and sheets

FastenersRail clips and self-drilling screws, coated to match

Matching & finish

Colorbond matchCurrent BlueScope range; nearest match on discontinued colours, sample shown first

Repair standardMatches or exceeds original build

Warranty

Repair warranty10 years workmanship; BlueScope warranty on new sheets

Insurance reportWritten, dated, insurer-ready

How We Repair

How a Colorbond repair goes

Site visit · 20min

Identify the colour and the sheet profile

We confirm the colour name, whether it is current, and the sheet profile, because BlueScope makes several and they do not interchange.

Same visit

Sheet, rail or run, in writing

The quote lists each sheet to replace, any rail or cap, and the colour match. If the colour is discontinued, the nearest-match sample is shown against the fence.

2 to 7 days

Sheets and parts ordered

Current colours in the standard profile are often in stock. Metallic and matt finishes, and unusual profiles, are ordered.

Half a day

Lift out, drop in, clip

The damaged sheet is lifted out of its rails, the new one slotted in, and rail clips fitted so it cannot blow out again. Rails and caps are swapped as parts.

Same visit

Seal and check the run

Any cut edge is sealed and touched up in the matched colour. We sight along the run for other sheets starting to rust at the edges and tell you.

The Difference

We match the colour before we order the sheet.

A Colorbond repair is only invisible if the colour is right. We identify the colour and the profile first, show you the sample against your fence, and tell you plainly when a discontinued colour cannot be matched.

10YRGUARANTEE

Backed in writing

Repaired by our own crews, guaranteed for a decade.

Not subcontracted, insurance-ready documentation, matching materials, fully insured, every time.

Hours

Sheet-by-sheet, same day where stocked

Standard-profile sheets in current colours are on the truck for most calls. One damaged sheet is a half-day job.

Claims

Storm blow-outs documented

Sheets blown out of sound rails are a storm claim. Report and quote in the insurer's format.

All

Matched, or told honestly

Current colours are exact. Discontinued ones get the nearest match, shown against your fence before we order, or a one-face replacement if you want it invisible.

10yr

Clips on every refit

Blown-out sheets usually mean the clips were never fitted. Every sheet we refit gets them, and we check the rail spec against your wind exposure.

Full

repair & make-safe

24hr

emergency response

Free

measure & quote

10 yr

workmanship guarantee

FAQ

Colorbond Fence Repair Melbourne questions

Straight answers on emergencies, insurance, and whether to repair or replace.

Ask us anything

Yes. The sheets carry no load; they slot into the rails. A damaged sheet is lifted out and a new one dropped in without disturbing the ones either side. Most Colorbond repairs are one to three sheets.

Local Coverage